Page 1 of 1
Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 4:26 pm
by SurfCityGene
Does anyone make the Viton float needle tips for the OF carbs since Stan is gone?
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 7:36 pm
by NoelChico
Following. Are special tools needed to install or perhaps "what tools are needed to install?'
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 8:07 pm
by Michael Peternell
Scott Conger is the guy.
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 9:28 pm
by ModelTWoods
There is also a guy in Missouri that makes MANY more Stromberg OF parts other than just the needle and seat assy. I have posted about him, previously, on the Forum, but forgot his name. I'll look for his name and post it when I find it.
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 9:55 pm
by Shannon_in_Texas
Terry,
Are you thinking of JR Means (Hot4Cyl on eBay) from Dunnegan, MO? His website is: jandshotrodasylum.com and his card says that he does engine rebuilding, coils, transmission repair, machine shop, magneto, and rebabbiting work.
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 9:58 pm
by ThreePedalTapDancer
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 10:17 pm
by Shannon_in_Texas
I have also gotten a replacement roller for the economizer arm made from stainless steel from him (not shown on his website).
Re: Stromberg OF Carb parts
Posted: Wed Apr 03, 2024 11:05 pm
by ModelTWoods
Shannon_in_Texas wrote: ↑Wed Apr 03, 2024 9:55 pm
Terry,
Are you thinking of JR Means (Hot4Cyl on eBay) from Dunnegan, MO? His website is: jandshotrodasylum.com and his card says that he does engine rebuilding, coils, transmission repair, machine shop, magneto, and rebabbiting work.
That's the Dude. I have one of his old parts sheets showing many more OF parts than his website shows. i bought a needle valve cap (the brass acorn nut on top of the float cover and a set of OF gaskets from him.