I was going to add a license plate bracket to the front the other day and when I looked I saw this. A lock washer, a washer and no cotter key. That’s not right, is it? Do I need to reinstall any washers? Just the bracket, nuts and cotter key?
It won’t let me add a picture….
Front Spring Installation
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Humblej
- Posts: 1957
- Joined: Sun Jan 06, 2019 12:23 pm
- First Name: Jeff
- Last Name: Humble
- * REQUIRED* Type and Year of Model Ts owned: 1926 Canadian coupe, 1924 TT C-cab, 1924 runabout
- Location: Charlevoix, Mi
- Board Member Since: 2006
Re: Front Spring Installation
Install a flat washer for a license plate bracket, but no lock washer when using a castle nut and cotter pin.
Good idea to check all your front end bolts for castle nuts and cotter pins while you are down there.
Good idea to check all your front end bolts for castle nuts and cotter pins while you are down there.
-
CatGuy
Topic author - Posts: 317
- Joined: Wed Apr 06, 2022 9:50 am
- First Name: Scott
- Last Name: Hunt
- * REQUIRED* Type and Year of Model Ts owned: '26 Runabout
- Location: Pella, Iowa
Re: Front Spring Installation
OK, Thanks! I'd better check everything over........