Clearance between crank and connecting rods
Posted: Thu Jun 27, 2019 8:03 am
Started final assembly of my 22 motor. New valves, lifters and rings. Ready to shim but need the specs for connecting rods to cram. Engine is original specs.
MTFCA Forum
Model T Ford Club of America
https://www.mtfca.com/phpBB3/
Clearance between crank and connecting rods
Page 1 of 1
Re: Clarence between crank and connecting rods.
Posted: Thu Jun 27, 2019 8:08 am
One and a half thou. .0015"
Re: Clarence between crank and connecting rods.
Posted: Thu Jun 27, 2019 9:10 am
Fit the bearings with time saver yellow and it will give you the right clearance.
Re: Clarence between crank and connecting rods.
Posted: Thu Jun 27, 2019 9:36 am
Re: Clarence between crank and connecting rods.
Posted: Thu Jun 27, 2019 10:44 am
I hope Clarence is OK 
Re: Clarence between crank and connecting rods.
Posted: Thu Jun 27, 2019 11:11 am
Clarence got his wings !! Re: Clarence between crank and connecting rods.
Posted: Fri Jun 28, 2019 1:15 am
yep, I suggest that Clarence gets out from between the crank and connecting rods before anything gets tightened up... 