Page 1 of 1
We Have All Been Here, Right?
Posted: Tue Aug 06, 2019 8:52 pm
by Henry K. Lee
THE PYRAMID OF PERSUASION!
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 12:35 am
by Wayne Sheldon
I do like the "I wasn't asking"!
Also, a lot of truth to that "Can't be tight if its a liquid".
Good stuff! Thanks for sharing those.
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 1:01 am
by Steve Jelf
All that's missing is the six-foot cheater stuck on the handle of the big wrench. 
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 8:06 am
by Rich Bingham
wayne sheldon wrote: ↑Wed Aug 07, 2019 12:35 am
. . . a lot of truth to that "Can't be tight if its a liquid".
you can disassemble practically anything with a cutting torch !
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 9:27 am
by JTT3
Henry, I noticed you missed in your tool assortment the BFH as an adjunct to the other tools.
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 10:14 am
by Dennis Prince
By the time I get to the directional forge there is usually a box of band aids involved as well.
Re: We Have All Been Here, Right?
Posted: Wed Aug 07, 2019 10:33 am
by Ruxstel24
I had to heat a carrier bearing housing on a front axle half shaft the other day...I had to get away for a couple hours from the garage being smoked up so bad !! It was rough !
Sometimes the flaming nut buster is the only option.
