MTFCA Forum

They look like suspension parts and are new but I don't recognize them.

And body supports of some kind?
. Jeff

Jeff, the 1st photo is 26-27 T windshield risers for roadster or touring.
Not sure on second photo but looks like aftermarket shocks or overload springs.

Dallas is correct on both counts !

RajoRacer wrote: ↑

Tue Sep 24, 2019 11:42 am

Dallas is correct on both counts !

How do overload springs work???

I have a full set - front & rear but mine have ball bearings where yours have brass wear plates - I believe the perch was reversed like Hassler installation required and those work with the original springs - Dan T. most likely has an advertisement for them - I do too somewhere.

Here's a few adv. on these.

Have rear set only on the '23 cut-off pickup. Gives the wood bed a nice ride with loads, and kicks the frame up a tad.

On the front axle, have '26-'27 spindles that lower it, provides a nice rake to the chassis, truck like


This version on the rear , have large ball bearings on the leading edge to glide over the leaf spring. The flange keeps the spring stack in place as you remove the leaf clamp.

Very interesting. Thanks for the info!

Jeff

Thanks Dan !

Dan the Man!