Page 1 of 1
Foundry run
Posted: Wed Oct 30, 2019 2:51 pm
by D.Yoder
- K parts
Re: Foundry run
Posted: Wed Oct 30, 2019 5:31 pm
by Russ T Fender
Nice castings, who do you use? I have some things I need to get done and your castings look like they do a fantastic job!
Re: Foundry run
Posted: Wed Oct 30, 2019 8:52 pm
by AndyClary
I'll bite. I see little muscle arms, but what are the larger pieces?
Andy
Re: Foundry run
Posted: Wed Oct 30, 2019 10:44 pm
by D.Yoder
The small pieces are timer roller holders for a K timer.
The large parts are the bottom 15 inches of a
6-40 steering column
Re: Foundry run
Posted: Wed Oct 30, 2019 11:06 pm
by Burger in Spokane
You are supplying these to NAPA for all the people who come in needing K parts, right ?
Re: Foundry run
Posted: Wed Oct 30, 2019 11:47 pm
by AndyClary
They look like good castings, what material was used. Were the roller arms lost wax?
Andy
Re: Foundry run
Posted: Thu Oct 31, 2019 11:08 am
by D.Yoder
Brass. Just sand castings. Better than making out of a billet .