Page 1 of 1

WTB, original Universal Ball Cap Screws, T-3371

Posted: Sat Feb 08, 2020 9:01 pm
by Pep C Strebeck
Just as the subject line says, I am in need of at least 4 (preferably 6) good, original cap screws for the Universal Joint Ball Cap. These are the 2 lower bolts with the cross-drilled heads for the safety wire, T-3371, 3/8-24 x 13/16. I set these aside so I would not lose them, and as with most folks, I didn't lose them, I just can't find them. Please let me know what you might have available, you can contact me through a Private Message here on the Forum or through e-mail. A Private Message has more of a guarantee of being seen, e-mails from Forum members always seem to go into my spam folder. Thanks for looking and for any help, Joe.

Re: WTB, original Universal Ball Cap Screws, T-3371

Posted: Sun Feb 09, 2020 12:27 pm
by Steve Robbins
I did the same thing! Finally got the rearend together and installed but when I looked for the bolts, They are nowhere to be found! So I used some temps till I find them! That should teach me to not cleanup all the nuts, Washers, bolts, and cotter pins.STEVE

Re: WTB, original Universal Ball Cap Screws, T-3371

Posted: Mon Feb 10, 2020 11:25 am
by Pep C Strebeck
nancydrew1.jpg
nancydrew1.jpg (84.02 KiB) Viewed 1921 times
Thought it was better than 10 characters. Still looking.

Re: WTB, original Universal Ball Cap Screws, T-3371

Posted: Wed Feb 12, 2020 1:49 pm
by Pep C Strebeck
haystack.jpg
haystack.jpg (27.44 KiB) Viewed 1850 times
Success! Replacements are on the way and I am sure that someday in the future I may find the ones I set aside so I would not lose them.