WTB starting crank

Post parts wanted or for sale here

Topic author
Rod Petrie
Posts: 66
Joined: Sun Jun 16, 2019 10:44 am
First Name: Rod
Last Name: Petrie
Location: Thedford, Ne

WTB starting crank

Post by Rod Petrie » Sat Jun 05, 2021 8:49 am

WTB starting crank for 26TT

Posts: 214
Joined: Mon Jan 07, 2019 12:44 am
First Name: Bob
Last Name: Shirley
Location: Atlanta Tx
MTFCA Number: 29135

Re: WTB starting crank

Post by BobShirleyAtlantaTx » Sat Jun 05, 2021 11:18 am

It’s a easy project, 1 inch cold roll and 3/4 conduit. You’ll have to slit the conduit close it and tig or mig the joint, using the stock to keep the weld flat on the inside, not as difficult as one would think. Heat the stock for sharp bends after you do a little lathe work. Bob @ 903-eight 24-1949 if I can help.

Posts: 83
Joined: Sat Jan 12, 2019 9:02 am
First Name: Steve
Last Name: McClelland
Location: Cleveland, Tn.

Re: WTB starting crank

Post by Runabout » Sat Jun 05, 2021 7:12 pm

Message sent in email.

Bill Crosby
Posts: 161
Joined: Tue Jan 08, 2019 5:33 pm
First Name: Bill
Last Name: Crosby
Location: Webster, NY
Board Member Since: 2016

Re: WTB starting crank

Post by Bill Crosby » Sat Jun 05, 2021 8:23 pm

Rod, Email sent.

Post Reply Previous topicNext topic