MTFCA Forum

I am looking for a piece of 3/4” brass tubing about 18” in length. This for my speedster to hold the ignition wires.
Thanks
Ralph

The hobiest choice for flats & tubes are K&S products. Might try local hardware or hobby shops. My local, across the river, hardware store that has everything has one, I believe its a 2 pack, ea 36" long for $29.99 which seems to be a decent price. Make 4 wire holders and sell 3.
Order from you local hardware store, Aubuchon Hardware, they sell K&S products its UPC code 614121192256
https://kkhardware.shoptruevalue.com/p/ ... 4121192256 --
--
also on eBay
one of these is a Grainger Supplier

amazon....

Our True Value Hardware sales brass pipe and brass fittings up to 3/4 inch.

Try McMaster Carr

Couldn't remember this supplier had ordered from 3 different ones in the past. Was very prompt & accurate, They have a coupon for 15% but there may be qualifications - shipping $$ because of length Best to get a few more inches then needed
https://www.onlinemetals.com/en/buy/bra ... e-seamless --
--
Took a look at the suggested sites & the K&S online store
Amazon shows it & highligts Visit the K&S Store. I did and it is not listed there. I also when directly to the K&S web site (different than Amazon's rendition)& its not listed there as well so it may suffer "supply chainitis"
https://www.amazon.com/9225-Round-Brass ... 262&sr=8-1 --
--
McMaster-Car selling in 12" and 36" lengths but offers thicker wall
https://www.mcmaster.com/tubing/shape~r ... und-tubes/
-- --
--
Plumbing pipe is usually red brass