Page 1 of 1
Got one - WTB - Gas head lamp, glass mirror insert
Posted: Fri Jan 13, 2023 5:07 pm
by Model-T&A
Thank you to all the forum members for checking out my search. I was successful in obtaining a replacement.
The Forum is the place to go for advice and parts. A great community for our hobby.
Rick
WTB - Glass mirror insert for a Victor Lamp Co. gas head lamp. Looking for good glass and I can have it re-mirrored if needed.
Thanks,
Rick
Re: WTB - Gas head lamp, glass mirror insert
Posted: Sun Jan 15, 2023 5:03 pm
by RajoRacer
Best I can do is a 6" X 1 & 1/2"
Addendum: I re-measured the height - its a smidge over 1 & 9/16".
Re: WTB - Gas head lamp, glass mirror insert
Posted: Mon Jan 16, 2023 12:16 pm
by Model-T&A
Hi Steve,
Thank you for your reply, and to all the forum members for reading my post.
I will recheck my measurement today and get back to you. Fingers crossed.
Thanks,
Rick
Re: WTB - Gas head lamp, glass mirror insert
Posted: Mon Jan 16, 2023 1:58 pm
by Model-T&A
Hi Steve,
Remeasured and it appears that your mirror should fit. Mine is 6" wide and depth is 1-11/16", attached is a poor man's drawing of the measurements of the bevel. For what it is worth my mirror is etched with the manufacturer Lancaster Glass Corporation - Ohio U.S.A.
I will send a PM with my contact information.
Thank you to everyone who took the time to read my post.
Rick