Page 1 of 1
Looking for a new cam.
Posted: Wed Feb 15, 2023 12:24 pm
by Paperman
Anyone have a camshaft for a 27 ? Seems the common vendors are out of stock.
Re: Looking for a new cam.
Posted: Wed Feb 15, 2023 1:36 pm
by ModelTWoods
I'll have several good low mile used reground ones when I get around to pulling them from the motors they are in. One was sold to me as a N.O.S. Ford cam, and it miked out that way. Has been installed in a motor, but never run. Another cam is in a motor built by a well know professional T engine builder, so it is probably a regrind, but has very low running time. another is in a motor my Dad had professionally rebuilt by in the late 1960's, and again, has very low miles on it, but more than the second cam mentioned. May be a while before I get to pulling them, but will offer them and some EE cranks on the Classifieds.
Re: Looking for a new cam.
Posted: Wed Feb 15, 2023 1:42 pm
by speedytinc
Have you tried Chaffins garage? They carry a wide variety of cams stock to hot.
Either way You should get a modern ground/new unit for its accuracy.