Page 1 of 1
drive shaft tap
Posted: Wed Feb 15, 2023 10:23 pm
by TLeroux
WTB drive shaft tap 13/32x16 tap
tom
Re: drive shaft tap
Posted: Thu Feb 16, 2023 8:44 am
by Dan Hatch
I may have an extra one. I will look. Email me
Re: drive shaft tap
Posted: Thu Feb 16, 2023 10:17 am
by Dan Hatch
I don’t have an extra one.
I may look into making another batch if there’s interest. Dan
Re: drive shaft tap
Posted: Thu Feb 16, 2023 10:45 am
by havnfun
Dan, I’d like to buy one or two if you get them made
Re: drive shaft tap
Posted: Thu Feb 16, 2023 11:17 am
by TLeroux
Dan
thanks I will buy 2 if you make them
tom
Re: drive shaft tap
Posted: Thu Feb 16, 2023 11:33 am
by speedytinc
Have you measured the OD of a 3/8-16 helicoil/thread insert tap?
If I was home I would measure one. If you dont have one, take your caliper over to Hilco.
Something in the back of my head spoke to me. They arent as hard to get as you would think.
Edit: Further investigation. The helicoil tap would be to big. It would work for a 7/16-16 bolt (Harley)
I gotta learn to ignore those voices.
Re: drive shaft tap
Posted: Thu Feb 16, 2023 1:50 pm
by Scott_Conger
Nothing wrong with trying to think outside of the box, John
Re: drive shaft tap
Posted: Thu Feb 16, 2023 8:27 pm
by Lemperesg
Please excuse my ignorance but, what is a drive shaft tap used for?
Re: drive shaft tap
Posted: Thu Feb 16, 2023 8:45 pm
by RajoRacer
The axle housing halves have a "special" thread that the d.s. spool studs/bolts use
Re: drive shaft tap
Posted: Thu Feb 16, 2023 9:37 pm
by TLeroux
I will Checking on having some Made.
stay tuned
Re: drive shaft tap
Posted: Fri Feb 17, 2023 9:53 am
by Scott_Conger