Page 1 of 1
Needed pieces.
Posted: Tue Dec 05, 2023 3:54 pm
by Dollisdad
One set of good front wheel bearings, races, washers and nuts.
One not so good same setup. For display, not road use.
One thrust washer and one steel washer for rear end for display.
Thanks
Re: Needed pieces.
Posted: Tue Dec 05, 2023 5:02 pm
by TRDxB2
Dollisdad wrote: ↑Tue Dec 05, 2023 3:54 pm
One set of good front wheel bearings, races, washers and nuts.
One not so good same setup. For display, not road use.
One thrust washer and one steel washer for rear end for display.
Thanks
Have most of that! Not sure about the inner bearings
For the outer sets : the Timken races are brand new. Have several used Timken VG sets of bearings. Also one not so good is a bit loose but very shiny not Timken. The thrust washer is brand new, used steel washer. Will send pictures in a PM later.
Re: Needed pieces.
Posted: Tue Dec 05, 2023 5:36 pm
by Original Smith
It would be nice if Tom would indicate what year bearings he's looking for!
Re: Needed pieces.
Posted: Tue Dec 05, 2023 6:38 pm
by TRDxB2
Good question. Assumed for this speedster, looks like wire wheels in the back but could be for another .....
Re: Needed pieces.
Posted: Tue Dec 05, 2023 9:23 pm
by TRDxB2
Dollisdad wrote: ↑Tue Dec 05, 2023 3:54 pm
One set of good front wheel bearings, races, washers and nuts.
One not so good same setup. For display, not road use.
One thrust washer and one steel washer for rear end for display.
Thanks
Sent you a PM RSVP email would be easier
Re: Needed pieces.
Posted: Tue Dec 05, 2023 9:48 pm
by Joe Bell
Tom, I have coffee cans of bearings and original thrust washer and some brass ones. Remind me the next time we see each other.