MTFCA Forum

I’m looking for a rear fender mount rod that screws into the rear quarter pillar for a Centerdoor Sedan.

You’d think the ones for tourings were the same, but they are not. They are 1/2 inch shorter than CD ones.

I thought I had found one at Luray, but alas, it is too short. (Only paid $5 for it, so no big loss)

The threads on the end are all the same. IF I had an acetylene torch I could straighten the one that I need to have fixed.

Just seeing what’s out there. These are not reproduced.

This what you are in search of? Jim
https://www.mtfca.com/phpBB3/viewtopic.php?f=2&t=43317

It is similar to that in length only. It doesn’t have the large boss on it. The two that I have are equal length. And are longer than touring ones.

This is what I’m looking for. The CD ones that I have are 8 inches in total length (including threaded area)

The one I bought is 1/2 inch shorter.

The diameter is the same on both. I know the threads posted above discussed what these look like. But those were not what was on my body. And the body is ‘22

If the ones with the square boss are 100% correct for ‘22, then so be it. I guess I’ll never find them. (One of the mounts I cannot remove yet. It’s tight).

Pretty darn sure that is a forging not casting so could be done cold.

Mark Gregush wrote: ↑

Tue May 28, 2024 4:02 pm

Pretty darn sure that is a forging not casting so could be done cold.

I’ve tried that and my vise isn’t man enough. Even though it’s bolted to a table.

Please check your part stashes. Back to top

Will_Vanderburg wrote: ↑

Tue May 28, 2024 4:54 pm

Mark Gregush wrote: ↑

Tue May 28, 2024 4:02 pm

Pretty darn sure that is a forging not casting so could be done cold.

I’ve tried that and my vise isn’t man enough. Even though it’s bolted to a table.

big hammer and anvil!

Ok I’ll break out the BFH!

Will_Vanderburg wrote: ↑

Mon Jun 03, 2024 8:08 pm

Ok I’ll break out the BFH!