Page 1 of 1
FS RACING INTAKE MANIFOLD (SOLD)
Posted: Wed Jul 31, 2024 4:09 pm
by Mark Chaffin
I have two RAJO high volume intake manifolds available for purchase. These were designed for use on a boredout Model T flathead engine block. They are similar in design to the Winfield 2 up 2 down intake manifold. Ports are 1 3/8". Carburetor side throat diameter is 1 5/8". Bolt flange is Winfield Model M201 B size. Price is $200 each plus domestic shipping. Mark Chaffin (951) 805-0928
Re: FS RACING INTAKE MANIFOLD
Posted: Wed Jul 31, 2024 4:35 pm
by themadmodelt
VM/txt sent
Re: FS RACING INTAKE MANIFOLD
Posted: Wed Jul 31, 2024 11:53 pm
by Mark Chaffin
One sold to Dave. Thank you
Re: FS RACING INTAKE MANIFOLD
Posted: Thu Aug 01, 2024 7:56 am
by Ralph F
Mark would this manifold fit a roof liberty eight over head.
Fitz
Re: FS RACING INTAKE MANIFOLD
Posted: Fri Aug 02, 2024 1:19 am
by Kevin Pharis
Ralph F wrote: ↑Thu Aug 01, 2024 7:56 am
Mark would this manifold fit a roof liberty eight over head.
Fitz
Both the single intake and the dual intake port Roof heads have vertical mounting flange holes. No doubt port spacing is near identical tho as the ports are centered about the cylinder pairs
Re: FS RACING INTAKE MANIFOLD
Posted: Fri Aug 02, 2024 8:57 am
by Mark Chaffin
Thank you Kevin for the info.
Re: FS RACING INTAKE MANIFOLD
Posted: Fri Aug 02, 2024 9:33 am
by Ralph F
Thanks Kevin always good to get good information.
Fitz
Re: FS RACING INTAKE MANIFOLD
Posted: Fri Aug 09, 2024 6:43 pm
by Mark Chaffin
One remaining. This will be the last for use with a Ford Flathead engine.
Re: FS RACING INTAKE MANIFOLD
Posted: Tue Aug 13, 2024 12:48 pm
by blauvelt
Will take the last one.
Re: FS RACING INTAKE MANIFOLD
Posted: Tue Aug 13, 2024 2:52 pm
by Mark Chaffin
Sold to Doug. Thank you.