MTFCA Forum

I recently purchased a barn load of T parts. In the process of sorting it all out so what I have is not limited to the following:
I have a number of front wood wheel hubs.No time to clean them up (de-grease) or check the bearings out and if I did the price would be higher. Doubt if the bearings are any good. I am checking hub cap threads & keyways etc. $35 a hub w flange ( plus shipping )

Also have a number of spindles with spindle arms attached. I have checked these out: all good threads, keyways & good for a tight inner race. Have both round collar & flat collar left & rights (no 1926/27) $30 each plus shipping.
Local pickup is available as well

still available

2 sets pending

I am looking for thin ring hubs without the speedo ring cut.i am looking for Two sets with old bearing.can you help.
Can you send pictures of the pairs. Thanks Ray

Nikko012 wrote: ↑

Fri Oct 18, 2024 8:22 pm

I am looking for thin ring hubs without the speedo ring cut.i am looking for Two sets with old bearing.can you help.
Can you send pictures of the pairs. Thanks Ray

Don't have any

Do you have two match sets?

I will take Two sets, Please send pictures. Thin ring only,please.thanks Ray

What are you referring to as a "thin ring" Ray ?

I will take two sets, PM to follow.

VinTin23 wrote: ↑

Sun Oct 20, 2024 4:55 am

I will take two sets, PM to follow.

Responded to your PM

Have not heard from you on the two sets.
Thanks Ray

Nikko012 wrote: ↑

Thu Oct 24, 2024 11:28 am

Have not heard from you on the two sets.
Thanks Ray

Getting confused with two people each asking for 2 sets. Sent you a PM at 12.30pm Now I see you want two hubs, yes I have them will email you

VinTin23 wrote: ↑

Sun Oct 20, 2024 4:55 am

I will take two sets, PM to follow.

Getting confused with two people having RAY in their names & each asking for 2 sets. Sent you a PM yes I have them will email you

Great, thanks

bump da bump