Page 1 of 1
UPDATE Stevens Front Axle Tool Frame
Posted: Sat Nov 02, 2024 8:46 pm
by Jack Putnam, in Ohio
I have received a partial shipment from the founder and I have two frames that have not been spoken for. If you are wanting the Stevens Front Axle Tool Frame contact me through the forum.
They are priced at $285 plus USPS of $18, total $303. I will accept Paypal for these. I have additional castings on order as of 10/30/24. I do not have a delivery date for them. Jack Putnam
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Sun Nov 03, 2024 11:24 am
by lockettt's
Jack, I will take one if still available. Thanks, George Lockett
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Sun Nov 03, 2024 12:39 pm
by Jack Putnam, in Ohio
Yes George, message sent to you.
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Fri Nov 08, 2024 8:36 pm
by Jack Putnam, in Ohio
I still have a Steven's frame available.
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Tue Mar 04, 2025 8:35 am
by South Park Zephyr
Are any of them still available?
Scott
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Tue Mar 04, 2025 10:04 am
by Jack Putnam, in Ohio
I am awaiting castings from the foundry. They will be available again.
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Tue Mar 04, 2025 10:56 am
by South Park Zephyr
I would like one when they are available
Do you have a waiting list, or should I wait to see when you post availability?
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Wed Mar 05, 2025 6:45 am
by Steves Ts
Hi Jack, put me down for one of Your frames. Please let me know when they re available.
Thank You
Steve Meudt
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Wed Mar 05, 2025 4:44 pm
by Erik Barrett
Jack, put me down for one please.
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Wed Mar 05, 2025 9:05 pm
by dobro1956
Just want to say that the frames Jack makes and the reamers Dan makes are flawless. The are exactly as good as any original. But better because the reamers and taps are new and sharp. Not worn like a lot of originals
Re: UPDATE Stevens Front Axle Tool Frame
Posted: Wed Mar 05, 2025 10:24 pm
by JTT3
Even better Dan has the reamers made long so they can be sharpened!!!!!