MTFCA Forum

Howdy,

I’m looking for a brass era headlight fork license plate mounting bracket.

Joe, there was one which bolted around the headlight stalk on the electric headlights. It may be the same as the one you are searching for.

Allan from down under.

There are two that I am aware of
#871 for pre 1915 (2nd down on the left) --
--
#440 no picture but this has been reported for Canadian Models
--

Frank, that Canadian one is the one I recall. It should fit all single stork light mountings.

Allan from down under.

Looks like the Neverout #440 isn't the same as the Canadian mount & could be made quite easily --
--
Could be a DIY

Still looking….

Only one I ever found. Good luck.

The bracket pictured clamped to the fork is on my 1912 touring it was on the car in 1960 a complete running car my thought is it is from 1915 or later because the early Manitoba plates are short that is why there is an extra hole so I can put the 12 plates on the car . It is an original Winnipeg Manitoba Canada car built in Walkerville Ontario.

I stand corrected I found a ad from 1913 specialty auto parts New York NY states it will fit all fords form 1911 through 1913

This ad is from 1914 so they are a US item there should be loads of them out there Cheers Colin