MTFCA Forum

Anyone happen to have one of Bob's tail piece alignment castings not being utilized ? Top dollar paid or possible trade for "goodies" ! I realize there are other castings available but not to my liking ! Thanks for looking !

Picture of what it looks like please.

Steve: Have you talked to the guys that made the reproduction pan jigs? They may have some extra ones. They made pan jigs that were same as the original ones.

No, I haven't Dan - do you have any contact info ?

They had one for sale last year at Luray and they had an ad in T Times for a while. I will see if I got contact info. Your email here work?

Dan,
I too am looking for this.
Could I get the info as well?

Scott

I saw the photo but don't recall seeing any contact ? I get messages through the Forum just fine - thanks !

Here's the one Bob produced many years ago - new ones are whonky !

I might have mis-spelled Bob's last name - it might have been Schwarzer ??? CRS is creeping in !

Guys check your emails for his info. Dan

I thank you kindly, Dan !

Thank you,
Scott

BTT - anyone have an orphan ???

The pan jig I designed pulls and pushes everything into position with minimal need for beating. This includes the fourth main and a hump or sag in the pan/gasket rail. It has levers, and attachments that are thread driven and gauges to show correct fitment of the pan arms. When I am finished, you can slide a 3/8" rod through the pan arms and frame holes.

RajoRacer wrote: ↑

Wed May 21, 2025 8:19 pm

I might have mis-spelled Bob's last name - it might have been Schwarzer ??? CRS is creeping in !

I believe you have it correct.

He was a nice guy, fwiw.

The only hammering needed is on the pan rails from overzealous bolt tightening - I use hydraulics !

I just want to watch!!!!!

This what your looking for?

Yes, yes, it is Kim !!!

Thanks Kim & MTFCA - found one !

Anyone have a dimensional drawing of one? I would like to try and make one for my jig. Thanks Jim

I can measure mine up, Jim if that will help.

https://modeltford-my.sharepoint.com/:b ... 1&e=vTv3FV


Lang’s sent me this
I hope it helps

Scott

Can't retrieve it - I'm technically challenged !

Same here can't open it. Jim

Same here can't open it. Steve, If we can't get Scott's link to open that would give us another option. Thanks Jim

Sorry for the bad link
I screen shot the individual pages

A few more

I hope this helps

Steve Lang sent these to me, so the thanks should go to him, if this is what you need

Scott

Thanks Scott, this is just what I've been searching for. Jim

Jerry VanOoteghem wrote: ↑

Sat May 24, 2025 7:32 am

RajoRacer wrote: ↑

Wed May 21, 2025 8:19 pm

I might have mis-spelled Bob's last name - it might have been Schwarzer ??? CRS is creeping in !

I believe you have it correct.

He was a nice guy, fwiw.

Scherzer is the correct spelling. Nice Guy is an understatement. I was fortunate to have Bob as a shop teacher in high school. Three of my five old Fords are from his collection.

Thanks for the correction, Ed. And, thanks to Steve L. & Scott for the technical drawings !