Page 1 of 1
Trade Only. Reeder Low Head for Reeder High Head.
Posted: Sat May 31, 2025 12:06 am
by ModelTWoods
I have a Reeder low head. Its not for sale but I would trade even for a Reeder high head in equal, good usable condition. Any interest or takers?
Re: Trade Only. Reeder Low Head for Reeder High Head.
Posted: Mon Jun 02, 2025 2:18 pm
by bill_severn
Terry,
I may have the Reeder head to trade. I'm not sure if I have a low head or a high head. The head measures 2 1/2 inches to the head bolt holes. If I can add a photo, you can see for yourself.
Bill
936 four four three eight zero zero six
Re: Trade Only. Reeder Low Head for Reeder High Head.
Posted: Mon Jun 02, 2025 2:32 pm
by bill_severn
Terry,
If you are in San Antonio, I'll be in Spring Branch for Fathers Day.
Bill
Re: Trade Only. Reeder Low Head for Reeder High Head.
Posted: Tue Jun 03, 2025 12:53 am
by ModelTWoods
Bill, Can you post an additional picture showing the combustion chambers?
Re: Trade Only. Reeder Low Head for Reeder High Head.
Posted: Tue Jun 03, 2025 6:20 pm
by ModelTWoods
Forum Members, who was the manufacturer of the head shown in the above post that has: "VTH-1000-H and 20-27" beneath it? It doesn't appear to be a Reeder head. The combustion chamber is deeper. My Reeder head has a flat combustion chamber, much like a Prus head.
Re: Trade Only. Reeder Low Head for Reeder High Head.
Posted: Tue Jun 03, 2025 8:52 pm
by RVA23T
Terry, I posted about this head Last year : [/url]
www.mtfca.com/phpBB3/viewtopic.php?f=2& ... minum+head[/url]
and there was not a clear answer.
For photos of the head, here is the posting for sale I placed which Bill purchased this head:
www.mtfca.com/phpBB3/viewtopic.php?f=5& ... minum+head
The gentleman I purchased the head from is no longer with us so I can't ask him. I know he knew other T owners in my region, but I have yet to figure out who they are and if they are also not off on permanent tour.