MTFCA Forum

For Sale
Several lots (6-10) of left over parts from the improved Coupe project:
Large pics below, photographed on 1/4" grid paper.

6) Stainless Steel Rear Corner Patch Panels, rework required, lot $10
7) Spindle washer 2709, $0.50
8) License Plate bracket (modern), $1
9) Transmission inspection cover screws for lint filter, 1/8" longer.
Zinc Round head, slot drive, machine screw 5/16-18 x 1/2", lot $0.50
10) Radiator mounting complete set, lot $10
As-is, no warranty.
UPS or USPS shipping (no FedEx).
A. Please claim below what item.
B. Please send me a PM, include your full mailing address for a shipping quote.
C. Payment by check, USPS money order or PayPal (only if item is $10 or you are willing to pay the fee, sometimes $1.60).

6) Stainless Steel Rear Corner Patch Panels, rework required

7) Spindle washer 2709

8) License Plate bracket (modern)

9) Transmission inspection cover screws for lint filter, 1/8" longer.
Zinc Round head, slot drive, machine screw 5/16-18 x 1/2"

10) Radiator mounting complete set

6) Stainless Steel Rear Corner Patch Panels, rework required, lot $10

As far as I know these were never made in stainless.
Welding stainless to mild steel is not "normal" in car repair.
What is the story of these parts?

The corners are used stainless steel. I purchased steel corners from the vendors but they were inadequately small to replace the rust damage. I copied what I received but made taller. They definitely need rework from a body shop. Even though they were custom taller, they were still too small. I am using stainless steel corners and weld with "BLUE DEMON Stainless Steel Welding Wire, Mfr. Model ER308L-035-10. I purchased 10 reproduction patch panels in all but only 1 was formed correctly. 2 of the 9 panels I used and reworked while the remaining 7, I sold at a loss. Basically, I copied a less than perfect piece. If this is not within your skill set, then just pass it by.