Page 1 of 1
Want to buy left side rear #3 buffalo hub
Posted: Fri Mar 20, 2026 9:56 pm
by FlyingMerkel
I’m looking to buy a left side rear buffalo #3 hub. I also want to buy a complete set of #3 caps, as well as two wheel centers, or wheels. I have most of a set, and would like to complete it.
Re: Want to buy left side rear #3 buffalo hub
Posted: Fri Mar 20, 2026 9:58 pm
by FlyingMerkel
Here’s a picture of what I have.
Re: Want to buy left side rear #3 buffalo hub
Posted: Sat Mar 21, 2026 12:45 pm
by Kevin Pharis
Email sent
Re: Want to buy left side rear #3 buffalo hub
Posted: Sat Mar 21, 2026 2:15 pm
by Layden Butler
Would be curious to know what over size axle the rear hub was made to fit?
Too big for a T and I think too small for a TT.
Re: Want to buy left side rear #3 buffalo hub
Posted: Sat Mar 21, 2026 3:23 pm
by Kevin Pharis
I’m thinking yur lookin at a giant weld to hold in a replacement taper…
Re: Want to buy left side rear #3 buffalo hub
Posted: Sun Mar 22, 2026 7:48 pm
by FlyingMerkel
This isn’t model T size?
Re: Want to buy left side rear #3 buffalo hub
Posted: Sun Mar 22, 2026 8:05 pm
by speedytinc
A T axle is 1.062" where the taper starts. Try it on a bare axle. I see 1.187".
Re: Want to buy left side rear #3 buffalo hub
Posted: Sun Mar 22, 2026 8:15 pm
by FlyingMerkel
I’ll put a micrometer on it.
Re: Want to buy left side rear #3 buffalo hub
Posted: Mon Mar 23, 2026 7:44 am
by Allan
Daniel, rear Hayes wire wheel hubs, more often than not, have flogged out keyways. I fix these by machining down a good T hub and boring out the Hayes hub to take the machined T hub. You might be able to do the same to make that hub fit.
Allan from down under.