Page 1 of 1

Howell’s Roadster deck lid and lower panel

Posted: Fri Sep 06, 2019 12:16 pm
by fordt
FE295223-9993-4C25-B8F4-3D1695908B9D.jpeg
BCE8404F-A3FC-4985-96D8-953D328D05E0.jpeg
F67B45BB-061C-4825-8459-3B2CB6C55A6C.jpeg
3AB8B441-5FCE-4526-990E-70ABE7EDB86B.jpeg
Bought these from Howells years ago, understand he just started making the whole deck lid again recently. I’m going the Roadster pickup route instead.
$500 for both or $475/lid, $25/panel PLUS whatever UPS shipping would be from Comfort TX.
Also have the old whole trunk as well with the original deck lid. Contact for those picts....

Re: Howell’s Roadster deck lid and lower panel

Posted: Wed Sep 11, 2019 3:30 pm
by fordt
BTT

Re: Howell’s Roadster deck lid and lower panel

Posted: Thu Sep 12, 2019 11:56 am
by Chris Haynes
Howell's stuff is crap. No customer service either.

Re: Howell’s Roadster deck lid and lower panel

Posted: Sun Sep 15, 2019 11:59 am
by Kevin Pharis
I had a one of these deck lids on my ol roadster. I wouldn’t say it was crap... it definitely wasn’t perfect (either was my car), but was a lot better than nothing at all! From my perspective, the skin needed a few hours of tin work to raise some some much needed compound shape, and the inner panel needed to be adjusted to fit the opening, then reassembled. Not an impossible task

Re: Howell’s Roadster deck lid and lower panel

Posted: Sat Oct 19, 2019 1:39 pm
by fordt
Btt

Re: Howell’s Roadster deck lid and lower panel

Posted: Sat Oct 19, 2019 5:03 pm
by rgould1910
I just puchased a new hump for the trunk deck of a 27 roadster. Had it here 2 days after ordering it. Cost less than $50. Darn glad they had it.

Re: Howell’s Roadster deck lid and lower panel

Posted: Mon Oct 21, 2019 2:07 pm
by fordt
Yup, I don’t get the customer service gripes, my cowl pieces were here in 2 days as well

Re: Howell’s Roadster deck lid and lower panel

Posted: Mon Oct 21, 2019 2:55 pm
by John kuehn
I wouldn’t complain to much about their items. It’s not that bad and nobody else is making it. I’m glad at least somebody is making T sheet metal.