Page 1 of 1

FS Boring bar Mic

Posted: Sat Sep 07, 2019 3:18 pm
by Dan Hatch
If you do engine work you will know what this is. It is a direct read mic for setting a cutting bit on a boring bar, like a Tobin-Arp TA14. This is an extra one in my shop. It is for a 1&1/8 bar, but you could make a new base for it. There is one on eBay right now with starting bid of $495. You can buy this one for $300.00 + shipping. Email me at address in pictures. Dan

Re: FS Boring bar Mic

Posted: Sun Sep 08, 2019 7:40 am
by Dan Hatch
Btt

Re: FS Boring bar Mic

Posted: Tue Sep 10, 2019 7:31 am
by Dan Hatch
Btt

Re: FS Boring bar Mic

Posted: Thu Sep 12, 2019 6:40 am
by Dan Hatch
Btt

Re: FS Boring bar Mic

Posted: Sat Sep 14, 2019 7:44 am
by Dan Hatch
Btt

Re: FS Boring bar Mic

Posted: Sun Sep 22, 2019 7:27 am
by Dan Hatch
Btt

Re: FS Boring bar Mic

Posted: Wed Sep 25, 2019 8:50 pm
by Dan Hatch
Btt