Page 1 of 1

Spacer for Model A crankshaft in T block F/S

Posted: Wed Jan 08, 2020 7:22 pm
by Layden Butler
Aluminum spacer used when installing a Model A crankshaft in a Model T Ford block. $25, domestic postage $8.

Re: Spacer for Model A crankshaft in T block F/S

Posted: Fri Jan 10, 2020 6:51 pm
by Matt_A_1926
Layden, is this the spacer you use to set the higs head back and also you'll have to move the front a bit as well?

Re: Spacer for Model A crankshaft in T block F/S

Posted: Thu Jan 16, 2020 5:42 pm
by Layden Butler
Hogs head stays where it is. The block moves forward on the pan.

Re: Spacer for Model A crankshaft in T block F/S

Posted: Thu Jan 30, 2020 3:42 pm
by Layden Butler
To the top

Re: Spacer for Model A crankshaft in T block F/S

Posted: Sat Feb 01, 2020 3:55 pm
by Matt_A_1926
I'll take it. I was trying to send a pm here for my details but cant figure it.out. pm me if you can.

Re: Spacer for Model A crankshaft in T block F/S

Posted: Sat Feb 01, 2020 4:22 pm
by Mark Gregush
Type the email address just as shown in your outgoing email address block, no spaces and use .net NOT .com.