Page 1 of 1
Valves
Posted: Sat Jul 04, 2020 1:10 pm
by dacapt1948
Hi there, I installed new stainless valves and adjustable lifters in my 1926 T. I just put the valve and lifters in and adjusted the valves to .014. Engine starts fine but engine lacks power. Should I have taken head off and re-time valves?
Thank you
Re: Valves
Posted: Sat Jul 04, 2020 5:03 pm
by Joe Bell
Did you lap in the valve seats? I recut the seats then lap them in for a good seal. Hope this helps.
Re: Valves
Posted: Sat Jul 04, 2020 9:52 pm
by Mark Gregush
"If you need help logging in, or have question about how something works, use the Support forum located here"
You need to ask your question on the main forum, this is not car support.