Howell’s Roadster deck lid and lower panel
-
Topic author - Posts: 81
- Joined: Wed Jun 19, 2019 5:21 pm
- First Name: Rob
- Last Name: Trippet
- Location: Comfort, TX
Howell’s Roadster deck lid and lower panel
$500 for both or $475/lid, $25/panel PLUS whatever UPS shipping would be from Comfort TX.
Also have the old whole trunk as well with the original deck lid. Contact for those picts....
-
- Posts: 205
- Joined: Tue Jun 25, 2019 8:00 pm
- First Name: Chris
- Last Name: Haynes
- Location: North Hills. CA
- Board Member Since: 2019
Re: Howell’s Roadster deck lid and lower panel
Howell's stuff is crap. No customer service either.
-
- Posts: 513
- Joined: Thu Jan 10, 2019 3:54 pm
- First Name: Kevin
- Last Name: Pharis
- Location: Sacramento CA
Re: Howell’s Roadster deck lid and lower panel
I had a one of these deck lids on my ol roadster. I wouldn’t say it was crap... it definitely wasn’t perfect (either was my car), but was a lot better than nothing at all! From my perspective, the skin needed a few hours of tin work to raise some some much needed compound shape, and the inner panel needed to be adjusted to fit the opening, then reassembled. Not an impossible task
-
- Posts: 333
- Joined: Tue Jan 22, 2019 8:16 am
- First Name: Richard
- Last Name: Gould
- Location: Folsom, CA
Re: Howell’s Roadster deck lid and lower panel
I just puchased a new hump for the trunk deck of a 27 roadster. Had it here 2 days after ordering it. Cost less than $50. Darn glad they had it.
-
Topic author - Posts: 81
- Joined: Wed Jun 19, 2019 5:21 pm
- First Name: Rob
- Last Name: Trippet
- Location: Comfort, TX
Re: Howell’s Roadster deck lid and lower panel
Yup, I don’t get the customer service gripes, my cowl pieces were here in 2 days as well
-
- Posts: 1453
- Joined: Sun Jan 06, 2019 8:00 pm
- First Name: John
- Last Name: Kuehn
- Location: Texas
- MTFCA Number: 28924
Re: Howell’s Roadster deck lid and lower panel
I wouldn’t complain to much about their items. It’s not that bad and nobody else is making it. I’m glad at least somebody is making T sheet metal.