Search found 8 matches

by jimuris
Mon Aug 03, 2020 8:11 pm
Forum: General Discussion Forum (started 2019)
Topic: 1926 Model T sediment bowl
Replies: 2
Views: 252

1926 Model T sediment bowl

Quick question, on the 26 sediment bowl the valve should face down to get the flow of fuel. There is a little hole inside on the shaft and that should face down correct.
by jimuris
Wed Apr 29, 2020 6:47 pm
Forum: General Discussion Forum (started 2019)
Topic: wiring harness
Replies: 1
Views: 338

wiring harness

I just installed a new firewall on my 14 T. Does the main wiring harness that attaches to the top of the coil box, go over the radiator support rod or under the support rod. I have been looking at original photos in books that I have, but it's tough to make out. I just want to make sure I am doing i...
by jimuris
Sun Jul 14, 2019 1:11 pm
Forum: General Discussion Forum (started 2019)
Topic: New Brassworks Radiator
Replies: 33
Views: 4433

Re: New Brassworks Radiator

Here are some pics of my issue.
by jimuris
Sat Jul 13, 2019 12:44 pm
Forum: General Discussion Forum (started 2019)
Topic: New Brassworks Radiator
Replies: 33
Views: 4433

Re: New Brassworks Radiator

It is leaning towards the back. You can see on the hose there is a little bump there. Also the hood is a little tight, now that you mention it. Maybe it is a simple fix, I will keep you posted. I will pull the car out tomorrow and take some pics.
by jimuris
Fri Jul 12, 2019 8:01 pm
Forum: General Discussion Forum (started 2019)
Topic: New Brassworks Radiator
Replies: 33
Views: 4433

Re: New Brassworks Radiator

The front motor mount is centered properly. To be honest I have put 225 miles on the T since putting on the new radiator. This is a fresh restoration . I remember now the radiator support rod I used was one that you take off the shelf. I had trouble putting it on then. I think it is a little short. ...
by jimuris
Wed Jul 10, 2019 7:52 pm
Forum: General Discussion Forum (started 2019)
Topic: New Brassworks Radiator
Replies: 33
Views: 4433

New Brassworks Radiator

Can anyone help me in figuring out why the goose neck on the new radiator does not align up with the top of the low cylinder head? I have aligned the frame rails, it is correct. It sounds like the front crossmember is bent somehow. It is a 14 T and I have the 2 leather pads under the radiator suppor...
by jimuris
Fri Jun 21, 2019 6:19 am
Forum: General Discussion Forum (started 2019)
Topic: 1914 seat tack strip
Replies: 2
Views: 561

Re: 1914 seat tack strip

Thanks a bunch for your help.
by jimuris
Thu Jun 20, 2019 8:49 pm
Forum: General Discussion Forum (started 2019)
Topic: 1914 seat tack strip
Replies: 2
Views: 561

1914 seat tack strip

Can anyone help me in the correct placement of the tacks on the hideum welt tack strip of my seats. The instructions say one inch, but I've seen pictures of original cars and it looks like three inches. I just want to make sure before I start poking in the tacks.