can someone give me dimensions or measurements for maximum movement that is acceptable for rear axle before rebuild.
Thank you.
rear axle end play
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
speedytinc
- Posts: 4725
- Joined: Fri Feb 12, 2021 12:24 pm
- First Name: john
- Last Name: karvaly
- * REQUIRED* Type and Year of Model Ts owned: 14/15 wide track roadster. 23 touring, 27 roadster pickup, 20ish rajo touring
- Location: orange, ca
- Board Member Since: 2020
Re: rear axle end play
Axles & carrier must freely rotate. .005" is perfect. .010" is acceptable.
-
Craig Leach
- Posts: 1906
- Joined: Tue Jan 08, 2019 12:22 am
- First Name: craig
- Last Name: leach
- * REQUIRED* Type and Year of Model Ts owned: 1919 Firetruck/1922 Speedster
- Location: Laveen Az
Re: rear axle end play
Thrust washers are about 1/4” thick if close to that it’s time to open it up. Ring gear to pinion clearance is.010 +/- .002 so if you have .025 or more then it’s worth a look. Best is to check these when a rebuild is done and write it down for reference in the future.
Craig.
Craig.