u-joint wear

Discuss all things Model T related.
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules

Topic author
donald4ham
Posts: 81
Joined: Tue Jan 08, 2019 12:19 pm
First Name: Donald
Last Name: Goodwin
Location: Medina Ohio
Board Member Since: 2018

u-joint wear

Post by donald4ham » Sat Dec 14, 2019 12:04 am

How much wear is too much on a u-joint before it is worn out?


Kerry
Posts: 308
Joined: Mon Jan 07, 2019 2:42 pm
First Name: Frank
Last Name: van Ekeren
Location: Rosedale Vic Australia

Re: u-joint wear

Post by Kerry » Sat Dec 14, 2019 1:41 am

By Ford specs, if more than .006" it's scrap.


Original Smith
Posts: 1203
Joined: Tue Jan 08, 2019 10:43 am
First Name: Larry
Last Name: Smith
Location: Lomita, California
MTFCA Number: 121
MTFCA Life Member: YES
MTFCI Number: 16310

Re: u-joint wear

Post by Original Smith » Sat Dec 14, 2019 10:26 am

Don't forget to pack the u joint area with a light grease.

User avatar

Pep C Strebeck
Posts: 146
Joined: Sun Jan 06, 2019 11:12 am
First Name: Joseph
Last Name: M
Location: MI
MTFCA Number: 0

Re: u-joint wear

Post by Pep C Strebeck » Sat Dec 14, 2019 1:47 pm

Kerry wrote:
Sat Dec 14, 2019 1:41 am
By Ford specs, if more than .006" it's scrap.
Frank is right on; Ford Model T Service, paragraph 591, "If there is over 0.006" clearance between knuckles and rings a new universal joint should be installed."

The rear axle booklet that is published by the MTFCA on page 17 says "The four bearings should also be tight with no more than 0.010 - 0.020 inch clearance."

While doing the most recent rear axle overhaul I was fortunate enough to have a N.O.S. Ford universal joint and the clearance was 0.0025" to 0.003" depending on which trunion/knuckle you would check. There is quite a discrepancy between the Ford specification and the MTFCA booklet, 0.006" versus 0.010" to 0.020" of clearance. If anyone has a new replacement/reproduction universal joint on hand, I would definitely be interested in knowing what the new manufacture ones are coming in at.

And Larry is right, don't forget to pack the u-joint bell at the front of the driveshaft housing, prior to re-installation. After I would run a newly installed u-joint (rebuilt rear axle) for a little bit, I would always add some more grease. The spinning and centrifugal force will spin out some of the grease and create a void in and around the u-joint, pack it back through the grease cup.
"Remember son, there are two ways to do this: The right way, and your way” Thanks Dad, I love you too.

LOOKING FOR A LUFKIN Model 1671A Center Punch.

Post Reply Previous topicNext topic