FS Several lots (6-10) of left over parts from the improved Coupe project:

[varmint]

For Sale
Several lots (6-10) of left over parts from the improved Coupe project:
Large pics below, photographed on 1/4" grid paper.

6) Stainless Steel Rear Corner Patch Panels, rework required, lot $10

rear corners icon.jpg (3.97 KiB) Viewed 284 times

7) Spindle washer 2709, $0.50

spindle washer 2709 icon.jpg (2.24 KiB) Viewed 284 times

8) License Plate bracket (modern), $1

LP bracket icon.jpg (3.48 KiB) Viewed 284 times

9) Transmission inspection cover screws for lint filter, 1/8" longer.
Zinc Round head, slot drive, machine screw 5/16-18 x 1/2", lot $0.50

Trans inspection cover icon.jpg (3.16 KiB) Viewed 284 times

10) Radiator mounting complete set, lot $10

Radiator mounting icon.jpg (5.18 KiB) Viewed 284 times

As-is, no warranty.
UPS or USPS shipping (no FedEx).
A. Please claim below what item.
B. Please send me a PM, include your full mailing address for a shipping quote.
C. Payment by check, USPS money order or PayPal (only if item is $10 or you are willing to pay the fee, sometimes $1.60).

[varmint]

6) Stainless Steel Rear Corner Patch Panels, rework required

[varmint]

7) Spindle washer 2709

spindle washer 2709 front.jpg (42.02 KiB) Viewed 283 times

spindle washer 2709 back.jpg (43.67 KiB) Viewed 283 times

[varmint]

8) License Plate bracket (modern)

[varmint]

9) Transmission inspection cover screws for lint filter, 1/8" longer.
Zinc Round head, slot drive, machine screw 5/16-18 x 1/2"

[varmint]

10) Radiator mounting complete set

[Mike Silbert]

6) Stainless Steel Rear Corner Patch Panels, rework required, lot $10

As far as I know these were never made in stainless.
Welding stainless to mild steel is not "normal" in car repair.
What is the story of these parts?

[varmint]

The corners are used stainless steel. I purchased steel corners from the vendors but they were inadequately small to replace the rust damage. I copied what I received but made taller. They definitely need rework from a body shop. Even though they were custom taller, they were still too small. I am using stainless steel corners and weld with "BLUE DEMON Stainless Steel Welding Wire, Mfr. Model ER308L-035-10. I purchased 10 reproduction patch panels in all but only 1 was formed correctly. 2 of the 9 panels I used and reworked while the remaining 7, I sold at a loss. Basically, I copied a less than perfect piece. If this is not within your skill set, then just pass it by.