OT: Stromberg OD-1 carburetor part needed choke part

Mark Gregush · Post by **Mark Gregush** » Fri Dec 30, 2022 12:30 pm

Know you guys have "other" stuff in your collection so thought I would ask here too.
Looking for the elbow(s?) that holds the choke and is mounted to main body of a made for Dodge Brothers Stromberg OD-1 carb. The mounting holes would be approximately 1-7/8" center to center. I was hoping the part from my OS-1 would fit but was too wide. While there are 4 holes showing, the mount only uses 2. At this point I would be happy with just the elbow the choke mounts in with butterfly. Assembly #P8712 in the drawing.

Thanks

Bruce Compton · Post by **Bruce Compton** » Fri Dec 30, 2022 11:16 pm

Mark : Check with Russ Potter as he ended up with a big box of Stromberg parts (OF and other models) from the Stan Howe auction.

Mark Gregush · Post by **Mark Gregush** » Sat Dec 31, 2022 11:23 am

Thank you. Will definitely give that a try.

Mark Gregush · Post by **Mark Gregush** » Wed Feb 01, 2023 3:10 pm

Bump back to top
Thanks

Mark Gregush · Post by **Mark Gregush** » Tue Mar 21, 2023 10:09 pm

30+ days bump

MTFCA Forum

OT: Stromberg OD-1 carburetor part needed choke part

OT: Stromberg OD-1 carburetor part needed choke part

Re: OT: Stromberg OD-1 carburetor part needed choke part

Re: OT: Stromberg OD-1 carburetor part needed choke part

Re: OT: Stromberg OD-1 carburetor part needed choke part

Re: OT: Stromberg OD-1 carburetor part needed choke part