Question 1: First three photos...the lower glass channel is physically too long to fit. My original shows glass protruding past the channel. How long should it be?
- window channel 01.jpg (34.22 KiB) Viewed 52 times
Question 2: Photo 4...the knob on the reproduction regulator does not spin. Is it supposed to roll or merely slide?
- window channel 05.jpg (17.1 KiB) Viewed 52 times
Question 3: Photo 5...the channel for the "roller" (not the channel for the glass) does not extend all the way to support the knob when lowered. When I shorten the channel, should I cut all the excess from the A-pillar side?