Ok so I’ve decided to run a model a manifold setup and carb on my TT. The manifold kit is on its way and I have a Model A Marvel carb ready to rebuild. My block is the later 27 with no hole between cylinders 2 and 3. I would like to set it up to run the throttle off of the column rod so I’m just wondering what others have done to rig something up. My google searches have all but come up with nothing.
Brad
Model A carb and manifolds.
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
jsaylor
- Posts: 411
- Joined: Sun Jan 06, 2019 5:25 pm
- First Name: John
- Last Name: Saylor
- * REQUIRED* Type and Year of Model Ts owned: 1921 Touring, 1927 Tudor
- Location: Citrus Heights, Ca
- Board Member Since: 1999
Re: Model A carb and manifolds.
Here is a photo of what I did to use the over the top linkage on a Winfield Carb. My engine was originally a Vaporizer. When I bought the car it had a Model A Zenith using this setup that I modified for the Winfield. For the Zenith choke a couple of 1/4" drive universals were braised into the choke/adjuster rod.
- Attachments
-
- zenith control m.JPG (27.06 KiB) Viewed 924 times
-
- Linkage.JPG (57.05 KiB) Viewed 924 times