Found my tap and one low head bolt. Thought you guys would like to see it. Bolt of is just below .500”.
Stevens T-201 Tap and bolt
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Dan Hatch
Topic author - Posts: 5018
- Joined: Tue Jan 08, 2019 7:31 pm
- First Name: Dan
- Last Name: Hatch
- Location: Alabama
Stevens T-201 Tap and bolt
After the thread about the tap from the Stevens T201/202 block retread kit I dug in my stuff cause I use to have some.
Found my tap and one low head bolt. Thought you guys would like to see it. Bolt of is just below .500”.
Found my tap and one low head bolt. Thought you guys would like to see it. Bolt of is just below .500”.
-
Scott_Conger
- Posts: 6523
- Joined: Sun Jan 06, 2019 11:18 am
- First Name: Scott
- Last Name: Conger
- * REQUIRED* Type and Year of Model Ts owned: 1919
- Location: not near anywhere, WY
- Board Member Since: 2005
Re: Stevens T-201 Tap and bolt
Neat!
thanks for the pix, Dan!
thanks for the pix, Dan!
Scott Conger
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves™
Obsolete carburetor parts manufactured
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves™
Obsolete carburetor parts manufactured