After hours of trying, I can't get the center bearing bolt installed. Hours spread over days! My engine is in the car so I'm using mirrors and faith to align the bearing hole. Both are failing me. I mic'd the shell hole and my new bolt. There is a clearance of .003". I took an old bolt and ground a rounded tip. I'm using that as a tool to line things up. That worked on the front bearing after 1.5 hours.
It's not working on the center bearing. What am I missing? Thoughts? Prayers?
What is the trick to install cam bearing bolts? Solved
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Mark Nunn
Topic author - Posts: 1241
- Joined: Mon Jan 07, 2019 8:01 am
- First Name: Mark
- Last Name: Nunn
- * REQUIRED* Type and Year of Model Ts owned: 1926 Runabout
- Location: Bennington, NE
- Board Member Since: 2017
What is the trick to install cam bearing bolts? Solved
Last edited by Mark Nunn on Tue May 14, 2024 9:48 pm, edited 1 time in total.
-
John kuehn
- Posts: 4434
- Joined: Sun Jan 06, 2019 8:00 pm
- First Name: John
- Last Name: Kuehn
- * REQUIRED* Type and Year of Model Ts owned: 19 Roadster, 21 Touring, 24 Coupe
- Location: Texas
Re: What is the trick to install cam bearing bolts?
Use 2 taper punches at the same time on the holes. Slowly get them centered. Leave one in the hole and remove the other and then try to get the cam bolt in the one you removed the taper punch in. I’m just guessing but sometimes it may work.
You might need to modify the punch ends a little to get it to work better.
You might need to modify the punch ends a little to get it to work better.
-
RajoRacer
- Posts: 5174
- Joined: Sun Jan 06, 2019 12:18 pm
- First Name: Steve
- Last Name: Tomaso
- * REQUIRED* Type and Year of Model Ts owned: 1914 Touring, 1919 Centerdoor, 1924 TT C-Cab Express, 1925 Racer
- Location: Longbranch, WA
- Board Member Since: 2001
Re: What is the trick to install cam bearing bolts?
A bit tricky but did you align the bearing with the lock bolts in alignment with the block holes ? Can be a challenge in the car !
-
Mark Nunn
Topic author - Posts: 1241
- Joined: Mon Jan 07, 2019 8:01 am
- First Name: Mark
- Last Name: Nunn
- * REQUIRED* Type and Year of Model Ts owned: 1926 Runabout
- Location: Bennington, NE
- Board Member Since: 2017
Re: What is the trick to install cam bearing bolts?
I got the job done. It was a beautiful evening and the turkeys were in the yard. So I took a break and enjoyed a cold beer. Then I manhandled that SOB in place.
My tapered alignment bolt would not go in with just a hand grip on a deep socket. I used a ratchet to drive it in and push the shell to where it needed to go. Then I swapped that for my new bolt. Thanks for the replies.
My tapered alignment bolt would not go in with just a hand grip on a deep socket. I used a ratchet to drive it in and push the shell to where it needed to go. Then I swapped that for my new bolt. Thanks for the replies.