For sale; 290 cam for $290

[Adam]

Here is a used re-ground cam. I checked one lobe and it shows about .287” lift, so maybe that’s what they ground it to, or maybe it was originally .290 and has .003 wear. I have no idea who ground it or any other specifics. It was in an engine I bought for parts. Includes bearings in picture and the bronze rear bearing that was in the block with it. First $290 plus shipping gets it. Inside the USA only, please. Email if you want it. Include your address so I can figure shipping. I don’t get pm’s and might not see a post here. Thanks.

[ModelTMark]

Adam,

I don't believe that's how you measure the lift of a camshaft. It's a ratio calculated by the lobe nose to heel measurement minus the measurement of the base circle.

R/Mark

[Jerry VanOoteghem]

Adam,

I don't believe that's how you measure the lift of a camshaft. It's a ratio calculated by the lobe nose to heel measurement minus the measurement of the base circle.

R/Mark

If he zeroed his indicator on the base circle, then what he shows & states is correct.

[Adam]

Please ignore the comment by Modeltmark, he doesn’t understand what he’s looking at. Jerry did get it correct. Thanks Jerry. It IS exactly what it IS.

[Tallpaul]

Adam, is your .290 cam still for sale?

[Adam]

Email if you want it. Include your address so I can figure shipping. I don’t get pm’s and might not see a post here. Thanks.

Still available. $290 plus shipping gets it.

[Adam]

To the top